Introduction; Equipment - ESAB Warrior Feed 304 Manuel D'instructions

US
This product is solely intended for arc welding. Any other use may result in personal
injury and / or equipment damage.
Dispose of electronic equipment at the recycling facility!
In observance of European Directive 2002/96/EC on Waste Electrical and Electronic
Equipment and its implementation in accordance with national law, electrical and/or
electronic equipment that has reached the end of its life must be disposed of at a
recycling facility.
As the person responsible for the equipment, it is your responsibility to obtain
information on approved collection stations.
For further information contact the nearest ESAB dealer.
ESAB can provide you with all necessary welding protection and accessories.
5

INTRODUCTION

The Warrior Feed 304, Warrior Feed 304w wire feed unit is intended for GMAW-
(MIG/MAG)-welding together with welding power sources:
S
Warrior 400i CC/CV
S
Warrior 500i CC/CV
They come in different variants, see page 61.
The wire feed units are sealed and contain four-wheel drive wire feed mechanisms
as well as control electronics.
They can be used together with wire on ESAB's MarathonPac, or on wire bobbin
(standard Ø 12 inch, accessory Ø 17 inch).
The wire feed unit can either be placed on the trolley, suspended above the
workplace with a lifting eye, on a counter balance or on the floor with or without
wheel set.
ESAB's accessories for the product can be found on page 64.
5.1

Equipment

The Warrior Feed 304, Warrior Feed 304w wire feed unit is supplied with:
S
Instruction manual
S
Sticker with recommended wear parts.
bm55d1a
- 10 -
© ESAB AB 2013