Getting Started; Electrical Connection; On/Off Switch - Festool CT MINI HEPA Guide D'utilisation

1.5
1.4
any damage or accident caused by using this ma-
chine for other than its intended purpose.

Getting started

The operating voltage shown on the specifi cation
plate must be the same as the mains power volt-
age (wall socket).
is switched off when you plug in the power cord.
The antistatic system (AS)
The friction of material running through the suc-
tion hose causes electrostatic charges, which
can result in unpleasant electric shocks for the
operator.
In order to prevent this, this dust extractor has an
integrated antistatic system which conducts these
static charges to ground. This requires the use of
antistatic hoses and accessories.
In position O (1.1) the dust extractor is switched
off and the tool plug socket (1.3) is dead.
Two modes of operation are possible:
a) Switch at "MAN" (manual control):
The tool plug socket is dead.
When you turn the switch to "MAN" the extractor
1.1
motor will start immediately and will stay on as
1.2
long as the switch is at this position.
1.3
You can use this mode of operation with out a tool
connected to the tool plug socket.
b) Switch at "Auto" (automatic tool-triggered
operation):
The tool plug socket is live.
"Auto" position, make sure that the tool connected
to the tool plug socket is switched off.
The cleaner motor starts only when the tool con-
nected to the appliance plug socket is switched
on.
6
The user is solely responsible for

Electrical connection

Make sure that the dust extractor

On/off switch

Before turning the switch to the