Features; Product Specifications - Ryobi RLS1351 Manuel D'utilisation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

PRODUCT SPECiFiCATiONS

Blade Diameter .............................................................5 in.
Blade Arbor .............................................................. 5/8 in.
Rip Capacity .................................................................8 in.
KNOw yOUR FLOORiNg SAw
See Figure 1, page 17.
The safe use of this product requires an understanding of
the information on the tool and in this operator's manual as
well as a knowledge of the project you are attempting. Before
use of this product, familiarize yourself with all operating
features and safety rules.
5 in. BLADE - A 5 in. blade is included with the saw. It will
cut materials up to 3/4 in. thick.
wARNiNg:
Do not use blades rated less than the speed of this tool.
Failure to heed this warning could result in personal
injury.
ANTi-KiCKBACK PAwLS (for use with rip cuts) - Kick-
back is a hazard in which the workpiece is thrown back
toward the operator. The teeth on the anti-kickback pawls
point away from the workpiece. If the workpiece should
be pulled back toward the operator, the teeth dig into the
workpiece to help prevent or reduce the possibility of kick-
back.
BLADE gUARD - Always keep the blade guard down and
over the saw blade for all cuts.
BLADE gUARD ADJUSTMENT KNOB - Set the clearance
of the workpiece using the blade guard adjustment knob.
Clearance between the workpiece and blade guard should
be set between 1/16 in. - 3/32 in.

FEATURES

Miter Capacity ............................................................11 in.
Input ...............................................120 V~, 60 Hz, 7 Amps
No Load Speed ...................................11,000 r/min. (RPM)
BLADE wRENCh STORAgE - A blade wrench is packed
with the saw. One end of the wrench is a phillips screw-
driver and the other end is a hex key. Use the hex key end
when installing or removing blade and the phillips end when
removing or loosening screws. A storage area for the blade
wrench is located under the saw's table.
CARRyiNg hANDLE - For convenience when carrying or
transporting the saw from one place to another, a carrying
handle has been provided on the side of the saw.
FENCE - The fence attaches to the saw table and can be
angled for miter cuts as well as placed straight for rip cuts.
With the locator pin in place, the clamp knob locks the fence
to the table at the desired cutting angle.
MiTER gROOVE - The attachment bolt rides in the miter
groove on the saw table to secure the fence in place when
making miter cuts.
ON/OFF SwiTCh - This saw has an easy access power
switch located on the front of the saw. To lock the switch in
the OFF position, remove the switch key from the switch.
Place the key in a location that is inaccessible to children
and others not qualified to use the tool.
RiP gROOVES - The attachment bolt rides in the rip groove
on the saw table to secure the fence in place when making
rip cuts.
RiViNg KNiFE - A metal piece, slightly thinner than the
saw blade which helps keep the kerf open and prevent
kickback.
9

Publicité

Table des Matières
loading

Table des Matières