Days 15 Thru 30 - Pet Monitoring; Taking Your Pet Out Of The Pet Area; Wireless-To-Go - Petsafe Stay & Play PIF17-13478 Manuel D'utilisation Et De Dressage

PHASE 5

Days 15 thru 30 - Pet Monitoring

Your pet is ready to run! Check in on your pet at regular intervals.
Note: After you are satisfied your pet's training is complete, remove every other Boundary Flag every 4 days until
all flags are removed. Save Boundary Flags for future use.

Taking Your Pet Out of the Pet Area

Important: Remove the Receiver Collar and leave it in the Pet Area.
Once your pet learns the Boundary Zone, he will be reluctant to cross it for walks or
car rides.
Option 1: Replace the Receiver Collar with a regular collar. Put your pet in a car
that is within the Pet Area and drive him out of the Pet Area.
Option 2: Replace the Receiver Collar with a regular collar and lead. Walk your
pet out of the Pet Area while giving a command such as "OK" at a specific place of
the Boundary Zone (the end of your driveway, sidewalk, etc.). Always leave the Pet
Area with a lead at this place and your pet will associate leaving the Pet Area only on
a lead, only at this place, and only with a person. You may initially need to convince
your pet to leave the Pet Area with a food treat and lots of praise.
Note: You may also carry your pet out of the Pet Area.

Wireless-To-Go

Your PetSafe Stay & Play™ Compact Wireless Fence system is completely portable. Follow the set-up procedures
®
(Steps 1 through 4) wherever you wish to have containment of your pet. Re-establish the Pet Area and mark it with
Boundary Flags so your pet knows his Boundary Zone.
Note: If setting up in a metal building or vehicle, the maximum size of the Pet Area may be reduced. Be sure to
remove the Receiver Collar battery before turning off the Transmitter. If you want to power the Transmitter from a
car or other DC source, use an inverter rated for 50 watts or more.
petsafe.com 21