Fit The Receiver Collar - Petsafe Stay & Play PIF17-13478 Manuel D'utilisation Et De Dressage

STEP 6

Fit the Receiver Collar

Important: The proper fit and placement of your Receiver Collar is important for effective training and the Safety
of your pet. The Contact Points must have direct contact with your pet's skin on the underside of his neck.
Please read and follow the instructions in this manual. Proper fit of the collar is important. A
collar worn for too long or made too tight on the pet's neck may cause skin damage. Ranging
from redness to pressure ulcers; this condition is commonly known as bed sores.
• Avoid leaving the collar on the dog for more than 12 hours per day.
• When possible reposition the collar on the pet's neck every 1 to 2 hours.
• Check the fit to prevent excessive pressure; follow the instructions in this manual.
• Never connect a lead to the electronic collar; it will cause excessive pressure on
the contacts.
• When using a separate collar for a lead, don't put pressure on the electronic collar.
• Wash the dog's neck area and the contacts of the collar weekly with a damp cloth.
• Examine the contact area daily for signs of a rash or a sore.
• If a rash or sore is found, discontinue use of the collar until the skin has healed.
• If the condition persists beyond 48 hours, see your veterinarian.
• For additional information on bed sores and pressure necrosis, please visit our website.
These steps will help keep your pet secure and comfortable. Millions of pets are comfortable
while they wear stainless steel contacts. Some pets are sensitive to contact pressure. You may
find after some time that your pet is very tolerant of the collar. If so, you may relax some of
these precautions. It is important to continue daily checks of the contact area. If redness or
sores are found, discontinue use until the skin has fully healed.
You may need to trim the hair in the area of the Contact Points. Never shave the dog's neck;
this may lead to a rash or infection.
To assure a proper fit, please follow these steps:
1. Make sure Transmitter is not plugged in, and the receiver is turned off.
2. Start with your pet standing comfortably (6A).
3. To make it easier to hear the warning beep, place the Receiver Collar on your pet with
the PetSafe logo side of the Receiver facing your pet's chin.
®
4. Centre the Contact Points underneath your pet's neck, touching the skin. If your pet has
a long or thick coat, use the enclosed long Contact Points to reach through the hair.
You may need to trim the hair in the area of the Contact Points. Never shave the dog's neck;
this may lead to a rash or infection.
petsafe.com
6A
15