Hach LOC 100 Manuel D'utilisation page 71

6. Press Initialize RFID Tag.
7. Follow the onscreen instructions and hold the location RFID tag in
front of the photometer RFID module.
A sound confirms that the writing process has been successful.
8. The location RFID tag can be rewritten at any time. To do so,
confirm the "Overwrite location RFID tag" message with OK.
Read data and write on label
1. Switch on the LOC 100.
2. Read in the operator ID initialized on the photometer by holding the
LOC 100 above the operator RFID tag and briefly pressing the left
key. The LOC 100 attempts to read the tag for five seconds. Once
the tag has been read successfully, the operator ID is shown on the
screen. (This step is optional. The option to read out the operator
ID can be deactivated in the Configuration menu).
3. Read in the sample ID initialized on the photometer by holding the
LOC 100 above the location RFID tag and briefly pressing the left
key. The LOC 100 attempts to read the tag for five seconds. Once
the tag has been read successfully, the location ID is shown in the
display.
4. Write on the empty sample RFID ID tag by holding the LOC 100
over the label and pressing the right key. A successful transfer is
shown in the display.
Note: This method can be used to write sample RFID tags as many
times as required. Sample RFID tags are dishwasher-proof.
However, repeated cleaning, particularly at high temperatures, can
impair the function of the tag. Read out the RFID tag using the
photometer (Read out the sample RFID tag on the
check the sample RFID tag.
photometer) to
English 71