Drain Hose Connection; Power Cord Connection - Whirlpool WPRERADWMW9305 Instructions D'installation

DRAIN HOSE CONNECTION

19.
Connect drain hose
Small clamp
Rubber drain hose
connector
Stop
Place towel under drain hose to catch any water in drain hose.
Place the small (green) drain hose clamp onto the small end
of the drain hose. Push the new drain hose into the rubber
drain hose connector up to the drain hose stop.
20.
Slide clamp onto connector
Small clamp
Rubber drain hose
connector
Using pliers, squeeze open the small drain hose clamp,
and slide it onto the connector between stops.
21.
Hose clamp final position
Drain hose stop
Small clamp
Rubber drain hose
connector
NOTE: Route drain hose out the rear of the dishwasher.
14
Drain hose
Drain hose stop
Stop
Drain hose
Drain hose stop
Stop
Stop
Drain hose
Stop
Stop

POWER CORD CONNECTION

NOTE: If removing a previous dishwasher with a power cord,
you will need to transfer the power cord to the new dishwasher.
22.
Remove terminal box cover
Using a / " hex-head socket, nut driver, or Torx
1
4
screwdriver, remove terminal box cover. Retain for later use.
23.
Install strain relief
Install a UL Listed/CSA Approved metallic strain relief.
Make sure screw heads are facing to the left when tightening
conduit nut. Strain relief is provided with the power cord
kit. See the "Tools and Parts" section at the front of the
guide for part details and orders.
24.
Power cord – route cord
into terminal box
Route cord so that it does not touch dishwasher motor or
lower part of dishwasher tub. Pull cord through strain relief
in terminal box.
NOTE: A maximum of 2 power cord supply conductors (12 AWG
largest size) plus 1 grounding conductor are permitted in the
terminal box.
T20
® ®