Whirlpool WPRERADWMW9305 Instructions D'installation page 15

WARNING
Electrical Shock Hazard
Electrically ground dishwasher.
Connect ground wire to green ground connector in
terminal box.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
25.
Power cord – connect ground wire
Remove the ground connector screw and place it through the
ring terminal of the green ground wire of power cord. Reattach
and tighten the ground connector screw.
26.
Power cord – connect
remaining wires
Select UL Listed/CSA Approved twist-on wire connectors of
the proper size. See the "Tools and Parts" section at the front
of the guide for part details. Connect wires, black to black and
white to white, using the twist-on wire connectors.
NOTE: Do not pre-twist stranded wire. Twist on wire connector.
Gently tug on wires to be sure both are secured.
Ground
wire
Wiring configuration
27.
Power cord – secure cord
in strain relief
Tighten strain relief screws to secure cord.
28.
Power cord – reinstall terminal
box cover and wires
Place wires inside terminal box. Insert tabs on left side of cover.
Make sure wires are tucked inside the box and not pinched by
the cover. Use a / " hex-head socket, nut driver, or Torx
1
4
screwdriver, and the screw removed in Step 22 to secure the
terminal box cover.
If power cord supplied model, remove the first tie strap closest
to the plug to maximize the cord length. Do not remove any
other tie straps.
NOTE: Route power cord out the rear of the dishwasher.
Do not plug cord into an outlet until instructed to do so.
T20
® ®
15