Standard Accessories; Applications; Battery Removal/Installation - Hitachi DS 14DCL Mode D'emploi

SPECIFICATIONS
POWER TOOL
Model
No-load speed (Low/High)
Wood
(Thickness 18 mm)
Drilling
Metal
(Thickness 1.6 mm)
Capacity
Machine screw
Driving
Wood screw
Rechargeable battery
Weight
CHARGER
Model
Charging voltage
Weight

STANDARD ACCESSORIES

In addition to the main unit (1), the package contains the
accessories listed in the table below.
1 Plus driver bit (No. 2 × 65L) .................... 1
DS14DCL
2 Charger .................................................. 1
DS18DCL
3 Plastic case ............................................ 1
Standard accessories are subject to change without notice.
OPTIONAL ACCESSORIES (sold separately)
1. Battery (BCL1415 or BCL1430)
(For DS14DCL)
2. Battery (BCL1815)
(For DS18DCL)
Optional accessories are subject to change without notice.

APPLICATIONS

○ Driving and removing of machine screws, wood screws,
tapping screws, etc.
○ Drilling of various metals.
○ Drilling of various woods.

BATTERY REMOVAL/INSTALLATION

1. Battery removal
Hold the handle tightly and push the battery latch to
remove the battery (see Figs. 1 and 2).
CAUTION
Never short-circuit the battery.
2. Battery installation
Insert the battery while observing its polarities (see
Fig. 2).
DS14DCL
0 – 450 / 0 – 1250 min
30 mm
Steel: 12 mm
6 mm
6.2 mm (diameter) × 63 mm (length)
(Requires a pilot hole)
BCL1415: Li-ion
14.4 V (1.5 Ah 4 cells)
1.4 kg
UC18YKL
7.2 – 18 V
0.4 kg
-1
6.8 mm (diameter) × 50 mm (length)
BCL1430: Li-ion
BCL1815: Li-ion 18 V (1.5 Ah 5 cells)
14.4 V (3.0 Ah 8 cells)
1.8 kg
CHARGING
Before using the driver drill, charge the battery as follows.
1. Connect the charger's power cord to the receptacle.
When connecting
a receptacle, the pilot lamp will blink in red
(At 1-second intervals).
2. Insert the battery into the charger.
Firmly insert the battery into the charger till it contacts
the bottom of the charger and checking the polarities as
shown in Fig. 3.
CAUTION
If the batteries are inserted in the reverse direction, not
only recharging will become impossible, but it may also
cause problems in the charger such as a deformed
recharging terminal.
3. Charging
When inserting a battery in the charger, the pilot lamp
will light up continuously in red.
When the battery becomes fully recharged, the
pilot lamp will blink in red (At 1-second intervals).
(See Table 1)
(1) Pilot lamp indication
The indications of the pilot lamp will be as shown in
Table 1, according to the condition of the charger or the
rechargeable battery.
English
DS18DCL
0 – 450 / 0 – 1250 min
-1
38 mm
Steel: 13 mm
6 mm
(Requires a pilot hole)
1.6 kg
the plug of the charger to
9