Grasslin Talento 672 Mode D'emploi page 40

A switching OFF time is displayed here with 00:00 for all 7 days of the
week. You can change these individually or delete them with Clear.
The input is ended.
A free memory location is displayed for further settings or
Press the key 1x. The input is ended.
The Display shows the current time.
Note: The next switching command in the program sequence ends the
cycle. The switching command can be
Note: After the procedures
• read, modify or delete the time, date, switching program
• DCF synchronisation
• restoration of mains power the switching state of the time switch is
updated automatically.
This means that:
• impulse switching commands from earlier times are ignored
• active cycle switching commands are re-started with the programme
ON-switching time
Preselection for:
- Seconds
- Minutes
with the m key
Set the ON switching duration:
with the
Confirm with the Prog key
= ON or
18
key 01...99
= OFF.