Cycle Switching Commands - Grasslin Talento 672 Mode D'emploi

10. Cycle switching commands

You determine the times for cycle switching commands
Symbols:
The preselection for seconds or minutes is explained at the given time.
A cycle switching command consists of:
• Start time
• ON switching duration
• Cycle duration (ON switching duration + pause)
• End time
An end time is only required if the cycle must be ended at a certain
time. If you do not set an end time, the cycle switching commands
operate endlessly.
1. Example:
Start time
ON switching duration 10 minutes
Cycle duration
End time
2. Example:
Start time
ON switching duration 10 minutes
Cycle duration
End time
Start time
ON switching duration
10 minutes
Pause
Cycle duration
60 min.
= ON switching duration (1...99 sec. or 1...99 min.)
= cycle duration
Monday 09:00
60 minutes
Friday 19:00
Monday to Friday 09:00
60 minutes
Monday to Friday 19:00
Cycle duration
60 min.
(1...99 sec. or 1...99 min.)
Pause
16
End time