What To Do If - Becker Centronic SunWindControl SWC545 Notice De Montage Et D'utilisation

Assembly and Operating Instructions
Problem
Drive is not function-
ing, transmission
control light is not lit.
The transmitter does
not react after the
batteries have been
changed.
Drive is not function-
ing, transmission
control light is lit.
Transmission control
light is flashing and
the word BATTERY is
displayed.
The required drive is
not functioning.
Curtain/fabric does
not move into the end
position.
Automatic control
commands are not
executed.
46

What to do if ...?

Cause
1. Batteries are dead.
2. Batteries are incor-
rectly inserted.
Power supply has been
interrupted for too long.
1. Receiver outside the
radio range.
2. Transmitter is not
programmed in the
receiver.
Battery power is low.
Wrong group selected.
End position is not set.
1. Sliding switch not in the
"" position.
2. Winter setting is set to
ON.
3. The automatic sun
protection function
was interrupted by a
manual command.
Remedy
1. Insert new batteries.
2. Insert batteries cor-
rectly.
Press the RESET button.
Check settings.
1. Reduce distance to
the receiver.
2. Programme transmit-
ter.
Replace batteries.
Select correct group.
Set end position in
setting menu SUN END
POSITION or TIME END
POSITION.
1. Set sliding switch to the
"" position.
2. Set winter setting to
OFF.
3. Turn the sliding switch
from "" to "" and
back to "".