Becker Centronic SunWindControl SWC545 Notice De Montage Et D'utilisation page 39

SETTING
INTERMEDIATE POSITION, FABRIC TENSION/TILT, WINTER OFF/ON
INTERMEDIATE
POSITION
1. You have confirmed the menu items SUN t (DELAY t). INTERMEDIATE PO-
SITION appears.
2. The switching time for the INTERMEDIATE POSITION can be set using the
+/- buttons.
The switching time can be set in a matter of seconds. Alternatively, you can
move the shutter from the upper end position into the INTERMEDIATE POSI-
TION using the EXTEND/RETRACT buttons.
3. Press OK to confirm. FABRIC TENSION/TILT will appear.
4. The switching time for the FABRIC TENSION/TILT position can be set using
the +/- buttons. The switching time can be set in a few seconds. Alternatively,
you can move the shutter from the lower end position into the FABRIC TEN-
SION/TILT position using the EXTEND/RETRACT buttons.
Press OK to confirm.
5. You have confirmed the menu setting FABRIC TENSION/TILT. WINTER OFF/
ON appears.
6. Use the +/- button to switch the winter mode on or off.
Press OK to confirm your selection. The receiver acknowledges the selec-
tion.
Note
Manual extension should not occur, even if an extension control com-
mand is given. Check the setting.
7. The WINTER OFF/ON function is now set.
8. For further programming options in the SETTING menu refer to the next sec-
tion.
FABRIC TENSION/
TILT
WINTER
OFF/ON
de
en
fr
nl
39