Explanations - Becker Centronic SunWindControl SWC545 Notice De Montage Et D'utilisation

Manual/Automatic sliding switch
In the "" mode, only manual control commands and alarm signals are executed
(e.g.: by pressing RETRACTION, STOP, EXTENSION buttons and wind alarm).
When the sliding switch is set to "" mode, automatic control commands are
carried out (e.g. Automatic sun protection function, ...).
The automatic sun protection functions are interrupted if a manual operation is
executed during automatic mode. These functions are re-activated automati-
cally when the programmed threshold values are exceeded or undercut after
retraction or via switching the slide switch from "" to "" and back to "".
Transmission control light
A radio signal is indicated by the transmission control light being lit. If the battery
is running low, the transmission control light flashes during transmission. The
transmitter power and/or radio range is reduced when the battery is running low.
If the transmission control light is no longer lit when the pushbutton is pressed,
the batteries must be changed.
Group
Group control means controlling one or several receivers at the same time. The
programmed group is activated using a single command.
When the SWC545 is used, the groups are controlled using six radio channels.
Group pushbutton
The group pushbutton may be used to select up to 5 channels. Operation of the
individual channels is indicated by the relevant LED lighting up.
An additional channel is reserved for the central command. This is allocated
automatically. Operation of the central command is indicated by all five LEDs
lighting up.
Note
You can note the programmed groups on the label under the see-
through cover.

Explanations

de
en
fr
nl
29