Service And Repairs - Hitachi N 5008AB Mode D'emploi

English
4 Remove the jammed staple.
5 Put back the front nose and bridge piece with two bolts.
6 In case of frequent jam, contact a Hitachi authorized service center.
2. Maintenance chart (See page 19)
3. Operator troubleshooting (See page 20)
4. Storing
When not in use for an extended period, apply a thin coat of the lubricant to the steel parts
to avoid rust.
Do not store the Stapler in a cold weather environment.
Keep the Stapler in a warm area.
When not in use, the Stapler should be stored in a warm and dry place.
Keep out of reach children.
5. WARNING LABEL
Change the WARNING LABEL if missing
or damaged.
A new WARNING LABEL is available from
a Hitachi authorized service center.

SERVICE AND REPAIRS

● Only service personnel trained by Hitachi, distributor or em-
ployer shall repair the Stapler.
● Use only parts supplied or recommended by Hitachi for repair.
All quality Staplers will eventually require servicing or replacement of parts because of wear
from normal use.
NOTE:
Specifications are subject to change without any obligation on the part of HITACHI.
WARNING
— 18 —
Warning Label