Drive Shaft; Bevel Gear - Husqvarna 545RXT AutoTune Manuel D'utilisation

2. Open the 2 hooks that hold the filter frame.
3. Remove the filter frame and the air filter.
4. Examine and clean the filter housing with a brush.
5. Examine the filter. Replace the filter if it is dirty or
damaged.
CAUTION: Do not bend or fold the filter as
this can cause damage to the filter. A
damaged filter must always be replaced.
To clean a nylon air filter
1. Remove the air filter cover.
2. Release the hooks that holds the air filter.
3. Remove the air filter.
4. Examine and clean the filter housing with a brush.
5. Examine the filter. Clean the filter with warm soap
water. Replace the filter if it is damaged.
CAUTION: A damaged filter must always be
replaced.

Bevel gear

The bevel gear is filled to ¾ with grease at the factory.
Before use, make sure that the grease level has not
changed. Use Husqvarna special grease if it is
necessary to fill up. Do not change the grease in the
171 - 008 - 08.06.2020
bevel gear. Let servicing personnel do the repair of the
bevel gear.

Drive shaft

Lubricate the drive shaft at an interval of 3 months. Let a
service agent help you if you are not sure about the
procedure.
To attach and remove the locknut
WARNING: Stop the engine, use protective
gloves and be careful around the sharp
edges of the cutting attachment.
Use the locknut to attach some types of cutting
attachments. The locknut has a left thread.
23