Product Description; Symbols On The Product; Intended Use - Husqvarna 545RXT AutoTune Manuel D'utilisation

1. Grass blade
2. Saw blade
3. Trimmer head
4. Bevel gear
5. Grease fill cap, bevel gear
6. Shaft
7. Handle adjustment
8. Throttle trigger
9. Stop switch
10. Throttle trigger lockout
11. Suspension point
12. Fuel tank
13. Muffler
14. Spark plug cap and spark plug, below the cover
15. Starter rope handle
16. Air purge bulb
17. Air filter cover
18. Start button
19. Harness, quick-release mechanism
20. Harness, hip pad
21. Drive disc
22. Cutting attachment guard
23. Locknut
24. Support flange
25. Handlebar
26. Support cup
27. Transport guard
28. Hex key
29. Locking pin
30. Operator's manual
31. Socket wrench
32. Harness

Product description

The 545RXT AT, 545FX AT and 545FXT AT are
handheld engine units with interchangeable cutting
attachments. The engine has the AutoTune function.
AutoTune
The carburetor controls the speed of the engine through
the throttle. Air and fuel is mixed in the carburetor. The
AutoTune function adjusts the carburetor automatically
to get the correct air and fuel mixture. AutoTune adapts
the engine to local conditions, such as climate, altitude,
gasoline and type of 2-stroke oil.

Intended use

Use the product with a saw blade, a grass blade or a
trimmer head to cut different types of vegetation. Do not
use the product for other tasks than grass trimming,
grass clearing and forestry clearing. Use a saw blade to
cut fibrous types of wood. Use a grass blade or trimmer
head to cut grass.
171 - 008 - 08.06.2020
Note: National or local regulations can regulate the use.
Comply to given regulations.
Only use the product with accessories that are approved
by the manufacturer. Refer to

Symbols on the product

Stop.
WARNING! This product is dangerous.
Injury or death can occur to the operator or
bystanders if the product is not used
carefully and correctly. To prevent injury to
the operator or bystanders, read and obey
all safety instructions in the operator's
manual.
Please read the operator's manual carefully
and make sure that you understand the
instructions before use.
Use a protective helmet in locations where
objects can fall on you. Use approved
hearing protection. Use approved eye
protection.
Use approved protective gloves.
Use heavy-duty slip-resistant boots.
The product can cause objects to eject,
which can cause injury.
Maximum speed of the output shaft.
Keep a minimum distance of 15 m to
persons and animals during operation of the
product.
Risk of blade thrust if the cutting equipment
touches an object that it does not
immediately cut. The product can cut off
body parts. Keep a minimum of 15 m
distance to persons and animals during
operation of the product.
Accessories on page 28 .
3