Operation; Transport Safety Lock; Changing The Cutting Attachments - SilverCrest SHBS 3.7 B1 Mode D'emploi

BB*5$B%ERRN 6HLWH  0LWWZRFK  1RYHPEHU    

6. Operation

Regardless of the charging state of the battery, the 5in1 hair
and beard trimmer can always be mains-operated.
1. For mains operation, ensure that the hair and beard
trimmer|5 is switched off.
2. Connect the power unit|10 to the connector of the
hair and beard trimmer|5.
3. Insert the power unit|10 into a readily accessible wall
socket whose voltage matches the voltage stated on
the rating plate.
4. Switch on the device with the on/off switch|7.

6.1 Transport safety lock

When the transport safety lock is activated, the battery sym-
bol|8 flashes green 3 times.
• Press and hold the on/off switch|7 for approx. 3 sec-
onds to activate/deactivate the transport safety lock.
• By connecting the power unit|10, the transport safety
lock is deactivated, and also cannot be activated while
plugged in to the power supply.

6.2 Changing the cutting attachments

WARNING! Risk of injury!
Switch off the hair and beard trimmer|5, before you attach
or remove the attachments.
• Figure A: to remove the attachments|13,|3,|4,|12,
14 use your thumbs to press the attachment towards
the rear of the hair and beard trimmer|5.
90
GB