Operation With The Mains Power Adapter; Oiling The Cutting Units; Handling And Operation; Attaching/Changing The Cutting Length Attachments - SilverCrest SHBS 600 A1 Mode D'emploi

Operation with the mains power adapter

GB
IE
♦
♦
♦
♦

Oiling the cutting units

♦
♦

Handling and operation

Attaching/changing the cutting length attachments

♦
♦
♦
8
If your hair and beard trimmer stops working during shaving due to a discharged
or weak battery, you can continue shaving by plugging in the mains power
adapter .
9
Plug the cable plug of the mains power adapter
underside of the hair and beard trimmer.
To avoid injuries and damage to the appliance, always switch the appliance
off before connecting it to the power supply.
Plug the mains power adapter
power socket complying with the appliance specifi cations.
After 1–2 seconds, you can switch the appliance on by pressing the ON/OFF
switch . If the appliance does not start immediately, switch it off again and
6
wait around 1 minute before switching it on again.
We recommend that you oil the cutting unit
to ensure full mobility.
To do this, simply apply a couple of drops of blade oil (accessory) between the
blades, and then distribute it evenly.
Wipe off any access oil with a soft cloth. Use only non-corrosive oils such as
sewing machine oil.
The cutting length attachments
lengths (4/7/10/13/16/18/21/24/27/30 mm).
Push the respective cutting length attachment (
from above so that the two side rails slot into the provided guides.
Push the cutting length attachment (
the mounting points .
4
To remove the cutting length attachment, move the slide switch for cutting length
adjustment upwards (position 5) and then pull the cutting length attachment
5
( or ) upwards off the appliance.
10 11
into the socket
9
(wide-range voltage 100–240 V) into a
9
before fi rst use and after cleaning
and off er settings for 10 diff erent cutting
10 11
or
10 11
or ) down until it snaps into place on
10 11
on the
8
) onto the cutting unit
SHBS 600 A1