Cutting Hair - SilverCrest SHBS 3.7 B1 Mode D'emploi

BB*5$B%ERRN 6HLWH  0LWWZRFK  1RYHPEHU    

6.4 Cutting hair

Hair trimmer attachment|
NOTES:
• The hair to be dressed must be dry.
• The cutting length may deviate depending on the cut-
ting angle.
• Place a sheet or cape around throat and neck to pre-
vent cut-off hair from dropping into the collar.
• Comb the hair well.
• First, start with a comb attachment|2 with a longer cut-
ting length and then, in the course of the cutting pro-
cess, use shorter cutting lengths step by step.
• Start by cutting the hair in the neck or on the sides and
cut towards the centre of the head. Then, cut the front
section of the hair towards the centre of the head.
• Hold the hair and beard trimmer|5 in such a way that
the comb attachment|2 lies as flat as possible on the
head. Move the device evenly through the hair.
• If possible, cut against direction of hair growth.
• In order to catch all the hair, move the hair and beard
trimmer|5 several times through each section of the
hair.
• Comb the hair repeatedly and well.
• In order to achieve a straight cutting line for cutting
lengths over 12 mm, the hair and beard trimmer|5
should be passed through the hair several times from
different directions.
92
GB
13