Charging - SilverCrest SHBS 3.7 B1 Mode D'emploi

BB*5$B%ERRN 6HLWH  0LWWZRFK  1RYHPEHU    

5. Charging

NOTES:
• Before first use (without cable), and for every charging
procedure afterwards, charge the hair and beard trim-
mer|5 for approx. 90 minutes.
• When the batteries are almost empty, the plug sym-
bol|9 flashes in red. The device can then only be used
for a short time without being connected to the electric-
ity supply.
1. Place the battery charger|11 on a level surface.
2. Connect the power unit|10 to the battery charger|11.
3. Switch off the device with the on/off switch|7 if neces-
sary.
4. Insert the power unit|10 into a readily accessible wall
socket whose voltage matches the voltage stated on
the rating plate.
5. Put the hair and beard trimmer|5 into the battery
charger|11.
6. The plug symbol|9 is lit red and the battery is
charged. When the battery is fully charged, the bat-
tery symbol|8 flashes in blue. When the battery is ful-
ly charged, the device can be used for approximately
60 minutes without being connected to the power sup-
ply.
89
GB