Before Use; Charging; Oiling The Blades - SilverCrest HG02124A Instructions D'utilisation Et Consignes De Sécurité

Before use

Note: The product may be powered using the
built-in rechargeable battery or the plug-in mains
adapter.
Remove all parts from the package.

Charging

Note: Before first use, the rechargeable battery in
the product should be charged for at least 90 mi-
nutes. A charging time of 90 minutes is also requi-
red subsequently.
The product can be charged directly or indirectly by
using the charging base
Note: The charging process is shown on the
display of the charging display
battery-status display
10
Direct charging (see Fig. C)
To avoid injuries and damage to the product,
always switch the product off before charging
the battery (ON / OFF switch
„0" position).
Insert the cable plug of the plug-in mains ad-
apter into the socket on the underside of
7
the product.
Insert the plug-in mains adapter
socket which meets the product requirements.
Indirect charging (see Fig. D)
To avoid injuries and damage to the product,
always switch the product off before charging
the battery (ON / OFF switch
„0" position).
Connect the cable plug of the plug-in mains
adapter with the charging base
7
Place the product with the cutting unit
the recess of the charging base
upwards.
Insert the plug-in mains adapter
socket which meets the product requirements.
.
6
and the
9
.
set to the
3
into a
7
set to the
3
.
6
into
1
pointing
6
into a
7
Note: During the charging process, the red
charging display will light up and the battery
9
status display will show the battery level.
10
Note: As soon as the battery is charged, the
battery status display
10
charging display will continue to be red.
9
Note: You can use the product for up to approx.
60 minutes with a full battery without it being
connected to the power supply.
Note: When the battery is almost empty, the char-
ging display on the display will flash. Then, the
9
product may only be used for a short period of
time without being connected to the power supply.
Operating using the plug-in mains adapter
If the product stops working during use due to an
empty or insufficient battery, you can continue if
the plug-in mains adapter is connected.
Insert the cable plug of the plug-in mains ad-
apter into the socket on the underside of
7
the product.
To avoid injuries and damage to the product,
always switch the product off before connec-
ting to the plug-in mains adapter
Insert the plug-in mains adapter
cket which meets the product requirements.
After a few seconds you can switch on the pro-
duct by sliding the ON / OFF switch
the desired position for the desired speed. If
the product does not start working immedia-
tely, switch it off by sliding the ON / OFF
switch to the „0" position. Wait approx.
3
1 minute before you try to switch it on again.

Oiling the blades

It is recommended that you oil the blades before
first use and after cleaning to guarantee complete
functionality (see Fig. E).
Apply one or two drops of blade oil
ween the blades and distribute them evenly.
Wipe away any excess oil using a cloth.
You can also use any acid-free oil such as
sewing machine oil.
will switch off, while the
.
7
into a so-
7
into
3
bet-
14
GB/IE/NI 11