7.2.3 Line terminal
The line termination must be activated on a video door phone connected at the end of a line without a new
section restarting from the LINE OUT terminals.
Terminal insert (default)
7.3. INSTALLATION COMPLETION
Connect.
Fix the video door phone to the bracket.
1
2
7.4. PROGRAMMING THE INTERCOM FUNCTION
The system offers the option of programming 2 buttons (1
With the kit Ref. 1722/93 you can call up to 2 video door phones in the same apartment.
With the kit Ref. 1722/94 you have two calling options:
•
up to 2 video door phones in the same apartment,
•
1 video door phone in the same apartment and all video door phones of the other apartment.
To programme the buttons:
•
Go to the indoor station to be programmed as caller (indoor station A).
•
Press and hold
confi rmation beeps to confi rm the new setting.
•
Press the button to be programmed as "caller" (
confi rmation tone.
•
Go to the indoor station to be called by that button (indoor station B) and press the door-key button. The
indoor stations A and B will emit a beep to confi rm the new setting.
•
To exit the programming mode, press and hold
In any case, after 10 minutes the device will automatically quit the programming mode, saving
the edited parameters.
With the kit Ref. 1722/94, the call to a video door phone in the second apartment will
necessarily sound all video door phones in the apartment.
DS1722-139
Dip switch position
ON
1
2
3
To remove the video door
phone from the bracket, insert
the tip of a screwdriver into
the seating as indicated in the
fi gure and push the video door
phone upwards.
for more than 5 seconds; the red LED will fl ash slowly and the system will emit 3
Terminal not inserted
4
and
or
) for at least 3 seconds until you hear the
for more than 5 seconds on the indoor station A.
Dip switch position
1
2
) to make intercom calls.
ON
1
2
3
4
31