Terminal Pins Description; Button Functions; Indicator Leds - Urmet miro Mode D'emploi

2.1. TERMINAL PINS DESCRIPTION

}
S+
Supplementary ringer
S-
}
X2
Button
X1
}
Y2
Button
Y1
]
Floor call
CP
]
System bus connection
LINE IN
3.

BUTTON FUNCTIONS

State
STAND-BY
Button
Open
pedestrian
door
---
Yokis
function(
Yokis
function(
Auto-on
function
Garage door
opener
(*) To enter and exit programming state, hold button pressed for longer than 5 seconds. The yellow LED
will blink slowly to indicate that programming mode is selected. Programming mode will shut down in all
cases after the 10 minute timeout. Refer to the system booklet for how to program intercom calls.
( ) At the same time closing the contact between terminals Y1, Y2 (max 50 mA @ 24 Vdc).
1
( ) At the same time closing the contact between terminals X1, X2 (max 50 mA @ 24 Vdc).
2

3.1. INDICATOR LEDS

8. Green LED under the
On steady:
On blinking:
DS1750-014B
WAITING
FOR PICK-UP
DURING AUDIO OPERATION
(RECEIVING
CALL)
Open
pedestrian
door
I
f pressed in the operating
mode:
A) "Hands Free" ends the
conversation;
B) in "Push to talk":
Audio
— if pressed a long time, it
activation
— if short pressed it
Yokis
) function( )
1 1
Yokis
) function( )
2 2
Video
switching
Garage door
opener
button
call in progress
conversation ongoing
Open pedestrian door
enables the audio of the
door unit;
activates or terminates the
conversation.
Yokis function( )
1
Yokis function( )
2
Special function (default: 8)
Garage door opener
STAND-BY AND
PROGRAMMING*
BUTTON
VIDEO DOOR PHONE
PRESSED
IN STAND-BY)
Connect / disconnect
Open pedestrian
the automatic door
door
opening system
---
Yokis function( ) Yokis function(
1
Yokis function( ) Yokis function(
2
Programmable
Floor call ring tone
intercom call
selection (5 different
2 (Default: not
programmed)
Programmable
Door phone call ring
intercom call 1
tone (5 different ring
(Default: call to
switchboard)
STATE OF
(ONLY WITH
---
)
1
)
2
ring tones)
tones)
13