Installation - Urmet miro Mode D'emploi

2.

INSTALLATION

Install flush-mounting box at the height indicated in the drawing below.
Fix the bracket to the mounting box or to the wall as indicated.
Program the dip switches.
Box Mod. 503
n° 2 M3,5 x 19 mm
included
Connect.
Fix the video door phone to the bracket.
1
2
To connect the video door phone in in-out, it is necessary to remove the door, as indicated in the figure,
and insert the adaptor circuit Ref. 1750/50, following the instructions found in the booklet provided with
the product.
12
Box Ø 60 mm
n° 2 2,9 x 13 mm
countersunk screws
To remove the video door phone from the bracket,
insert the tip of a screwdriver into the seating as
indicated in the figure and push the video door
phone upwards.
1
n° 2 screws and screw
anchors included
1
2
2
DS1750-014B