Intercom Call Management; Video Switching; Opening The Doors; Auto Power-On - Urmet 1722 Notice D'installation Et D'utilisation

10.3. INTERCOM CALL MANAGEMENT

To make an intercom call:
• Press button
• Press or to send the call to the video door phone with which you want to establish a conversation
(see the procedure for programming the buttons under par. 7.4 PROGRAMMING THE INTERCOM
FUNCTION);
• While waiting for a response, the LED of button
• When the video door phone called responds, the LED of button
of the conversation;
• Press button

10.4. VIDEO SWITCHING

The call tone will be generated in alternating manner by the various video door phones after a call if "Slave"
video door phones (OP3) are present in the system. The "Master" video door phone will enable monitor
switch-on if the call is from a video calling station. In this case, during the call pick-up time (3 minutes from
the call), the video door phones of the other devices can be switched on by pressing the auto-on button
(video switching function) until one of the video door phones picks up.
The picture of the main camera will appear only on the device that picked up afterwards.
The camera picture will therefore be normally shown on only one apartment station at a time.

10.5. OPENING THE DOORS

During a call, during communication (audio on) or during auto-on it is possible to:
• activate the pedestrian gate electric lock by pressing
• activate the garage gate lock by pressing .

10.6. AUTO POWER-ON

Press to see the video stream of the calling station camera on the video door phone.
Auto-on is silent (audio is not turned on) and the calling station LEDs will be off. During auto-on, the video
stream of the camera will appear on the video door phone monitor. The green
button will light up.
To exit the auto-on function, press
While the video door phone is displaying the images of the calling station, it is possible to:
• Turn the audio on to speak with the calling station by pressing B (the conversation can be interrupted at
any time by pressing button
The camera LEDs will light up when audio is turned on.

10.7. CALL TONE MUTING

It is possible to adjust the call volume to the point of excluding the ring tone (Mute) by moving the sliding
cursor (see section 10.1 DESCRIPTION OF THE FRONT OF THE VIDEO DOOR PHONE).
The mute state is indicated by a red signal visible in the upper part of the cursor.
If the cursor is set to MUTE during a call, the video module of the video door phone will turn on,
and all acoustic signals (beeps) and any additional ringtones will be disabled.

10.8. SUPPLEMENTARY RINGER

The video door phones are provided with a pair of terminals (K, Z) for connecting a supplementary ringer.
This ringer is controlled when any call tone is generated.
DS1722-139
, which will start blinking green;
to stop the conversation.
(in any case, after 3 minutes the device automatically switches off).
).
is lit red;
remains lit green for the entire time
;
button and the red
39