Rear Spacers; Door Reversibility - AEG S53430CNW2 Notice D'utilisation

32 www.aeg.com

9.4 Rear spacers

You can find the two spacers in the bag
with documentation.
1. Release the screw.
2. Engage the spacer below the screw.
3. Turn the spacer to the right position.
4. Tighten again the screws.
9.5 Levelling
When placing the appliance ensure that
it stands level. This can be achieved by
two adjustable feet at the bottom in
front.

9.6 Door reversibility

WARNING!
Before carrying out any
operations, remove the plug
from the power socket.
CAUTION!
To carry out the following
operations, we suggest that
this be made with another
person that will keep a firm
hold on the doors of the
appliance during the
operations.
1. Open the door and empty the
shelves.
2
1
3
4
2. Unscrew the screws of the upper
hinge (1).
3. Remove the door from the middle
hinge pivot (2).
4. Place the cover of the upper hinge
into the holes on the opposite side.
5. Screw off the screws of the middle
hinge (3).
6. Remove the plugs on the upper side
of both doors and move them to the
other side.
7. Remove the lower door from the
lower hinge pivot (4).
8. Screw off the pivot of the lower hinge
(5) and screw the lower hinge pivot
(6) into the left drill of the lower
hinge.
1
2
4