Rear Spacers; Rehingeing The Door - AEG SANTO 70290-8 DT Mode D'emploi

Rear spacers

Inside the appliance you find two
spacers which must be fitted.
Slacken the screws and insert the
spacer under the screw head, then
re-tighten the screws.

Rehingeing the door

The side at which the door opens can be changed from the right side
(factory adjustment) to the left side, if the installation site requires.
Warning! When changing the side at which the door opens, the appliance
may not be connected to the mains. Remove plug from the mains
beforehand.
Procced as follows:
To carry
operations, we suggest that this be
made with another person that will
keep a firm hold on the doors of the
appliance during the operations.
- Open the doors, unscrew and
remove the middle hinge (H) pulling
away gradually from the refrigerator
cabinet, tilting slightly the two doors.
pay attention to remove the plastic
spacer inserted under the hinge.
- Take off the freezer door pulling
slightly downwards.
- Take off the refrigerator door
pulling slightly upwards the top.
- Remove the upper plastic plug of
the freezer door and reinsert on the
opposite side.
- Remove the upper plastic plug of
the refrigerator door and reinsert on
the opposite side.
- Unscrew the upper hinge pivot (G)
of the refrigerator and rescrew it on
the opposite side.
All manuals and user guides at all-guides.com
out the following
H
G
41