Installation; Packaging And Unpacking; Installation (Service Technician) - Bartscher FRE91M00 Manuel D'installation

8.

INSTALLATION

8.1.

Packaging and unpacking

During unloading and
appliance follow the
manufacturer placed directly on the packaging
and in this manual.
To lift and transport the product plan to use a fork
lift or stacker, and pay attention to even weight
distribution to avoid a risk of tilting of the
packaging (avoid excessive incline!).
When using the lifting equipment pay
attention to the mains cable, water supply and
discharge pipes and feet position.
The packaging consists of the carton packaging
and wooden pallet. There are symbols printed on
the carton packaging that according to the
international agreements
regulations to follow when loading and unloading,
transporting and storing the appliance.
THIS
FRAGILE
SIDE UP
8.2.

Installation (service technician)

All the stages of the installation must be carefully
planned.
The location should be equipped with all supply
connections and production waste outlet. The
location should also be properly lit and comply
with all hygiene and sanitary requirements
according to the binding regulations.
The appliance should be installed with the
minimum 5 cm clearance from the wall, if the wall
is not resistant to the minimum temperature of
150°C.
Locate the appliance in the horizontal position by
adjusting the single feet.
when installing the
information from the
inform about the
KEEP DRY
When collecting the goods check if the packaging
is complete and has not been damaged during
transport.
Any damage should be immediately reported to
the shipping company.
Unpack the appliance as soon as possible to
check if the appliance is not damaged.
Do not use a sharp object to cut the carton box. It
may damage the stainless steel inside the box.
Remove the carton packaging from bottom to top.
When unpacked check if the appliance is
according to the order.
In case of any difference inform the sales agent
immediately.
Do not store the packaging materials
(nylon bags, polystyrene foam, clips ...) in the
reach of children!
Remove the protective PVC layer from the out
and inner surfaces. If possible, do not use any
metal tools.
To ensure the correct operation of the
appliance, the appliance must be installed and
operated in the thoroughly ventilated room only.
11
ENGLISH
50
t
GB