Arjohuntleigh Nimbus 3 Mode D'emploi page 12

Nimbus 3 Pump The same pump is used on the
Mains Power Switch
Mains Power Cord
systems.
Professional
The pump comprises a moulded case with non-slip feet
on the base and rear, and an integral carry handle.
Carry Handle
Front Panel
The pump has two modes of operation:
• mode that cycles the support surface
Dynamic
beneath the patient every 10 minutes providing
periods of pressure relief for the whole body.
• mode where the support surface remains
Static
constant (all cells equally inflated).
The controls and indicators are located on the front
panel, and a sophisticated alarm system differentiates
between normal operation and genuine system faults. If
an alarm situation is detected a flashing indicator will
illuminate, together with an indication of the cause of
alarm, and an audible warning will sound.
The pump can be fixed to the foot end of a hospital bed
by the separate bed bracket. The bed bracket fits in the
pump handle and then clips onto most common bed
frames. The pump can also be stood on the floor, either
upright or on its rear cover.
2
Nimbus 3
Alarm Indicators
mm Hg
-
+
Hi
mmHg
mmHg
Lo
and
Nimbus 3
Tubeset