Care And Cleaning; General Information; Cleaning The Hob; Troubleshooting - AEG IAE84853FB Notice D'utilisation

10. CARE AND CLEANING

WARNING!
Refer to Safety chapters.

10.1 General information

• Clean the hob after each use.
• Always use cookware with a clean base.
• Scratches or dark stains on the surface
have no effect on how the hob operates.
• Use a special cleaner suitable for the
surface of the hob.
• Use a special scraper for the glass.
The printing on the flexible
induction cooking area may
become dirty or change its
colour from sliding the cookware.
You can clean the area in a
standard way.

10.2 Cleaning the hob

• Remove immediately: melted plastic,
plastic foil, sugar and food with sugar,

11. TROUBLESHOOTING

WARNING!
Refer to Safety chapters.
11.1 What to do if...
Problem
You cannot activate or operate the
hob.
22 ENGLISH
• Remove when the hob is sufficiently
• Remove shiny metallic discoloration:
• The surface of the hob has horizontal
Possible cause
The hob is not connected to an elec‐
trical supply or it is connected incor‐
rectly.
The fuse is blown.
You do not set the heat setting for
60 seconds.
You touched 2 or more sensor fields
at the same time.
Pause operates.
otherwise, the dirt can cause damage to
the hob. Take care to avoid burns. Use a
special hob scraper on the glass surface
at an acute angle and move the blade on
the surface.
cool: limescale rings, water rings, fat
stains, shiny metallic discoloration. Clean
the hob with a moist cloth and a non-
abrasive detergent. After cleaning, wipe
the hob dry with a soft cloth.
use a solution of water with vinegar and
clean the glass surface with a cloth.
grooves. Clean the hob with a moist cloth
and some detergent with smooth
movement from left to right. After
cleaning, wipe the hob dry with a soft
cloth from left to right.
Remedy
Check if the hob is correctly connec‐
ted to the electrical supply. Refer to
the connection diagram.
Make sure that the fuse is the cause
of the malfunction. If the fuse is
blown again and again, contact a
qualified electrician.
Activate the hob again and set the
heat setting in less than 60 seconds.
Touch only one sensor field.
Refer to "Daily use".