Operating State Led; Plug Connections - Dentsply Sirona CEREC AC Notice D'utilisation

Dentsply Sirona
Operating Instructions for the Acquisition Unit
66 37 461 D 3492
D 3492.201.06.27.02 09.2017
6.4.2

Operating state LED

A Operating state LED
B ON button
LED not lit:
LED lights up yellow: Acquisition unit is switched on at main switch,
LED lights up green: Acquisition unit is switched on at ON button and
6.4.3

Plug connections

NOTICE
The CEREC Omnicam is a high-precision optoelectronic scanning
instrument for non-contact impression taking which requires careful
handling. Incorrect handling (impacts, dropping) leads to failure of the
CEREC Omnicam.
➢ Always deposit the sensitive CEREC Omnicam in its holder!
NOTICE
Do not damage the cables
If you pull on the cable itself in order to unplug it or to check the plug
connection, you will damage the cable.
➢ Never pull on the cable.
➢ Slide the moving part of the plug-in coupling upward on the CEREC
AC. At the same time, hold the camera connector in place.
1. Connect the unit to the line voltage with the power cord.
2. Carefully insert the connector of the CEREC Omnicam cable into the
coupling on the CEREC AC, watching out for the guide nose.
3. Check the plug connections of the power supply and the camera. The
CEREC Omnicam always remains connected.
Acquisition unit is switched off at main switch.
Windows is shut down and the PC is switched
off.
ready for operation.
6 Installation and startup
A
B
31