Dentsply Sirona
Operating Instructions for the Acquisition Unit
66 37 461 D 3492
D 3492.201.06.27.02 09.2017
Components of the Omnicam
8.1.5.2
A
Press detent to release
B
Mirror sleeve
8.1.5.3
Removing the mirror sleeve
If required to remove the mirror sleeve do the following:
1. Press the mirror sleeve against the camera body.
2. Press detent A.
NOTICE
There is a risk of damaging the camera windows or the coated sapphire
glass, if the mirror sleeve is not pushed straight toward the front.
➢ Push the mirror sleeve straight toward the front – do not tilt.
3. Pull off the mirror sleeve.
8.1.5.4
Refitting the mirror sleeve
NOTICE
There is a risk of damaging the camera windows or the coated sapphire
glass, if the mirror sleeve is not pushed straight toward the camera body.
➢ The mirror sleeve must not come into contact with the camera
windows.
➢ Push the mirror sleeve straight toward the camera body – do not tilt.
➢ Carefully refit the mirror sleeve until it locks in place.
8 Maintenance
C
Sapphire glass (coated)
D
Camera windows
51