Operation; Camera Warm-Up Time; Adjusting The Cerec Omnicam - Dentsply Sirona CEREC AC Notice D'utilisation

Dentsply Sirona
Operating Instructions for the Acquisition Unit
66 37 461 D 3492
D 3492.201.06.27.02 09.2017
7

Operation

7.1

Camera warm-up time

When switching on the system, the camera needs to warm up for 15 - 20
minutes. If the coated sapphire glass of the Omnicam is not sufficiently
warm, it may steam up during the acquisition. As such, it is not possible
to carry out the exposure.
Following use, always position the Omnicam on the heater plate.
You can set the end temperature to which the camera heater warms the
Omnicam mirror sleeve.
1. In the software, navigate to the system menu and click on the
"Configuration"
"Devices"
2. Click on the
"Omnicam"
3. Click on the
"Camera Heater Settings"
4. Click on the
5. Use the slider to adjust the temperature.
7.2

Adjusting the CEREC Omnicam

You can adjust the CEREC Omnicam in the device configuration.
1. In the software, navigate to the system menu, and click on the
"Configuration"
"Devices"
2. Click on the
"Omnicam"
3. Click on the
Accepting settings
"Ok"
➢ Click on the
Discarding settings
"Cancel"
➢ Click on the
button.
button.
button.
button.
button.
button.
button.
button.
button.
7 Operation
39