Technical Data; Guarantee - ATIKA GHD 2800 Mode D'emploi

Fault
Shredding material is not
drawn into the shredder
Shredding material not cut
cleanly
Device starts but blocks
under as slight load and
switches off via protective
motor switch.
T e c h n i c a l d a t a
T e c h n i c a l d a t a
Model
Name
Motor
Motor rating P S6 - 40 %
1
Rotational speed cutting roller
ON/OFF-switch with
Weight
Sound pressure level at work L
(measured to 2000/14/EC)
Measured sound power level L
(measured to 2000/14/EC)
Guaranteed sound power level L
(measured to 2000/14/EC)
Max. branch diameter
(only for freshly cut wood)
Safety class
Protection class
Mains fuse
Switzerland
UK
G u a r a n t e e
G u a r a n t e e
Please observe the enclosed terms of guarantee.
14
Possible cause
- The cutting roller is running in reverse.
Wrong switch position.
- Shredding material caught in funnel
- Shredding material too soft or wet
- Cutting roller worn
- Fixed counter blade not adequately ad-
justed
Extension cable too long or cross-section to
small.
Socket too far from mains supply and cross-
section of mains cable too small
2300
AH 600
2300 W
overload protection; cutting and reverse function, zero-voltage initiator
24 kg
83,8 dB (A)
PA
K = 3 dB (A)
WA
91 dB (A)
WA
92 dB (A)
∅ max. 35 mm
16 A time-lag
10 A time-lag
13 A time-lag
Remedy
- Switch off device and switch over direction of rotation
selector switch.
- Switch off device. Switch the direction of rotation
selector switch into position
release the material to be shredded, remove any
foreign matter.
Switch off device again. To continue work, place the
direction of rotation selector switch back into position
.
- Push down with a branch and shred
- Adjust fixed counter blade as described under „adjust-
ing the fixed counter blade". In case of severe wear,
replace cutting roller.
- Adjust fixed counter blade
Extension cable at least 1.5 mm², maximum 25 m long. If
a longer cable is used, minimum cross-section 2.5 mm².
2500
AH 600
AC-Motor 230 V~, 50 Hz, 2800 rpm
2500 W
40 min
-1
24,5 kg
84,2 dB (A)
K = 3 dB (A)
91 dB (A)
92 dB (A)
∅ max. 40 mm
I
IP X4
16 A time-lag
--
13 A time-lag
. Switch on device to
2800
AH 600
2800 W
25 kg
82,5 dB (A)
K = 3 dB (A)
91 dB (A)
92 dB (A)
∅ max. 44 mm
16 A time-lag
--
13 A time-lag