Troubleshooting; Problem Finding - VESTEL VHDA55CS Mode D'emploi

7

Troubleshooting

7.1

Problem finding

• Only a qualified electrician may carry out any electrical repairs. All local
regulations must be followed. Contact the manufacturer in case of any
doubts.
• Unplug all power connections before opening the appliance.
Error
The light can be
switched on but the
motor does not work
Both the light and
motor do not work
Oil is leaking
The light is not working
There is insufficient
suction power/air is not
taken up adequately
The cooker hood is no
longer in a horizontal
position
50 | VESTEL VHDA55CS-VHDA80CS
Cause
Fan switch turned off
Fan switch broken
Motor broken
Fuse is broken
Power supply loose or
disconnected
The one-way valve and
the exhaust pipe are not
tightly sealed
There is leakage between
section and cover
The lamp is broken
The distance between
the cooker hood and the
cooking appliance is too
large
The screws or not tight
enough
Solution
Put the on/off switch in the
"I" or "II" position
Contact service centre
Contact service centre
Reset/Replace fuse
Connect power supply to
wall socket
Disassemble the one-way
valve and seal with sealant
Disassemble the section and
seal with sealant
Replace the lamp (see 7.2
Replacing the lamp)
Make sure the distance
between the cooker hood
and the cooking appliance
does not exceed 70 - 80cm
Tighten the screws and level
the cooker in a horizontal
position