Ndustrio 091CP1E Manuel D'utilisation Et D'installation page 35

LEVELLING
Adjust the floor-mounted feet (A) to level the appli-
ance.
ASSEMBLY APPLIANCES IN BANKS
To assemble appliances in banks (side by side)
proceed as described below.
1 - Pull off the knob (A).
2 - Undo the screws (C) and remove the control
panels (B).
3 - Apply masking tape to the edges to be placed
side by side.
4 - Apply food-approved sealant to the edges to be
placed side by side.
5 - Place the appliances side by side.
6 - Connect the appliance using the screws and
nuts (D-E).
7 - Remove the excess sealant and the masking
tape.
8 - Apply the sealant to the inside of the lid (F), and
fit it to cover the fixing zone.
9 - Replace the control panels (B) and the knobs
(A) on completion of the operation.
A variety of optional installation kits are available for
arranging appliances in banks:
G)"Bridge" installation kit
G
A
D
H)Supporting frame kit
L) Supporting beam kit
H
- 15 -
A
B
C
F
E
IDM-39615601400.tif
IT
IDM-39614401700.tif
GB
DE
FR
L
ES
IDM-39614401800.tif
English