Ryobi EWS1150RS Manuel D'utilisation page 7

EN
FR DE ES IT
 Support large panels to minimise the risk of blade
pinching and kickback. Large panels tend to sag
under their own weight. Supports must be placed
under the panel on both sides, near the line of cut and
near the edge of the panel.
 Do not use dull or damaged blades. Unsharpened
or improperly set blades produce narrow kerf causing
excessive friction, blade binding and kickback.
 Blade depth and bevel adjusting locking levers
must be tight and secure before making cut. If
blade adjustment shifts while cutting, it may cause
binding and kickback.
 Use extra caution when making a "plunge cut" into
existing walls or other blind areas. The protruding
blade may cut objects that can cause kickback.
SAFETY INSTRUCTIONS FOR SAWS WITH LOWER
GUARD
 Check lower guard for proper closing before each
use. Do not operate the saw if lower guard does
not move freely and close instantly. Never clamp
or tie the lower guard into the open position. If saw
is accidentally dropped, lower guard may be bent.
Raise the lower guard with the retracting handle and
make sure it moves freely and does not touch the
blade or any other part, in all angles and depths of cut.
 Check the operation of the lower guard spring.
If the guard and the spring are not operating
properly, they must be serviced before use. Lower
guard may operate sluggishly due to damaged parts,
gummy deposits, or a build-up of debris.
 Lower guard should be retracted manually only
for special cuts such as "plunge cuts" and "
compound cuts". Raise lower guard by retracting
handle and as soon as blade enters the material,
the lower guard must be released. For all other
sawing, the lower guard should operate automatically.
 Always observe that the lower guard is covering
the blade before placing saw down on bench or
floor. An unprotected, coasting blade will cause the
saw to walk backwards, cutting whatever is in its path.
Be aware of the time it takes for the blade to stop after
switch is released.
SPECIFICATIONS
Voltage 230 V - 240 V
Input 1150 W
No-load speed 5600 RPM
Bore size 20 mm
Blade size 170 mm
NL PT DA SV FI NO
English
50 Hz
RU PL CS HU RO LV
Blade
Thickness
Teeth
Width of cut
Cutting capacity
at 0º
at 45º
Bevel scale
STANDARD ACCESSORIES
 Saw blade
 Parallel fence
 Wrench
ASSEMBLY
Be sure to disconnect the tool from the power supply
before attaching or removing the saw blade. Be sure that
the teeth of the saw blade are pointing upward at the front
of the tool
INTENDED USE
Sawing wood.
Don't use it for a purpose not intended.
OPERATION
ATTACHING THE BLADE
See Figure 2-4.
1. Press and hold the spindle lock button.
2. Turn the hex-head bolt with a wrench until the spindle
locks.
3. Loosen the hex-head bolt by turning the wrench
anticlockwise.
4. Remove the hex-head bolt and the outer blade washer.
5. Retract the lower guard back with the lower guard
lever as far as possible under the upper guard.
6. Attach the saw blade against the inner blade washer
on the spindle.
7. Fit the outer blade washer and the hex-head bolt.
8. Tighten the hex-head bolt by turning the wrench
clockwise.
9. After tightening the hex-head bolt, release the spindle
lock button.
NOTE: When the blade has been installed, make sure
the spindle lock has been released by spinning the blade
freely.
2
LT ET HR SL SK EL
1.5 mm
12 T
2.2 mm
55 mm
38 mm
0 - 45º
TR