Operator; Intended Use - Carlo De Giorgi 554/00 Manuel D'utilisation Et D'entretien

STERIL INTRAPLANT
If the handpiece you intend to use has dual irrigation (see Fig. 4) connect
both the microtubes (A); if it is a single irrigation type (see Fig. 5) cut the
forked connection at the base of tube (1) and insert connector (2) into the
length of tube leading to the handset (3).
1
A
3
2
Fig. 4 Fig. 5
Now insert the power cable connector into socket (5) on the rear of the
appliance (see Fig. 2) and insert the power cable plug into a mains socket
outlet; the main power switch (6) and double protection fuse (8) are
shown in figure 2.
Now fit the required surgical handpiece (not supplied) on the micromotor.
Always switch OFF the appliance after use by setting the main
power switch to "0".

4.2 - OPERATOR

After powering on the appliance and selecting the required program, the
operator can start the micromotor by means of a voluntary command via
the footswitch, thereby assuming direct control of its operation.
NOTE: The 32 programs are preset in the factory with standard
parameters that the dental surgeon using the appliance can modify to suit
requirements.

4.3 - INTENDED USE

The micromotor for implantology is designed for use in dental surgeries
for surgical and implantological operations.
The appliance must not be used for any uses other than those specified
by the manufacturer.
Carlo de Giorgi GB - 7