Standards And General Precautions; Introduction; Description Of The Appliance; Reference Standards - Carlo De Giorgi 554/00 Manuel D'utilisation Et D'entretien

STERIL INTRAPLANT

1 - STANDARDS AND GENERAL PRECAUTIONS

1.1 - INTRODUCTION

This manual is the property of CARLO DE GIORGI S.r.l. The contents of
this manual cannot be reproduced or disclosed to other parties. All rights
reserved.

1.2 - DESCRIPTION OF THE APPLIANCE

The appliance is a micromotor for use in the dental sector for surgery and
implantology when equipped with an implantology handpiece.
This appliance must be used exclusively by persons with appropriate
training and qualifications and who have sufficient experience in the use
of this type of equipment. Before using the appliance it is mandatory to
have read the contents of this manual in their entirety and to know and
understand the position and function of all the relative commands, paying
particular attention to all the safety warnings and precautions prescribed
herein. Failure to comply with this requirement or incorrect use of the
appliance can result in injury to the operator, the patient and other
persons in the vicinity.
I
T IS STRICTLY FORBIDDEN TO OPEN OR REPAIR THE APPLIANCE
OF MALFUNCTIONS ALWAYS CONSULT

1.3 - REFERENCE STANDARDS

1.3.1 - Obligatory compliance

- EEC directive n.89/392 – Machinery Directive - (D.P.R. n° 459/1996)
- EEC directive n.73/23 – Low voltage Directive (Italian legislation: Law n°
791/1977, Decree Law n° 626/1996, Decree Law n° 277/97)
- EEC directive n.89/336 relative to Electromagnetic Compatibility (EMC) -
(Italian legislation: Decree Law n° 615/1996)
- DPR 27.4.1955 n.547, "Norme per la prevenzione degli infortuni sul lavoro"
(work accident prevention regulations)
- DPR 27.4.1956 n.303, "Norme generali per l'igiene del lavoro" (general work
hygiene regulations)
- Italian Decree Law 12 August 1991 n.277 implementing EEC directives
n.80/605; n.83/477; 86/188; 88/642 concerning the protection of workers
against risks deriving from exposure to chemical, physical and biological
agents in the workplace, as defined by art. 7 of Law 30 July 1990, n.212
1.3.2 – Voluntary compliance
- EN 292 (1992) Machine safety – Basic concepts; general design principles –
Part 1 – Basic terminology and methods (EN 292-1) /Part 2 – Specifications
and technical principles (EN 292-2).
Carlo de Giorgi
C G
ARLO DE IORGI
;
IN THE EVENT
.
GB - 3