Carlo De Giorgi 554/00 Manuel D'utilisation Et D'entretien page 23

STERIL INTRAPLANT
8
The main ON/OFF switch (black in colour) is located on the rear panel of
the appliance (6, Fig. 2).
The display data are shown in figure 8:
1) progressive program number (from 00 to 31);
2) motor/gear unit transmission ratio (must be set in accordance with the
type of handpiece installed); available settings are: 1:1 - 1:2 - 1:3 - 1:4
- 1:6 - 1:10 - 1:16 - 1:20 - 1:33 - 1:50 - 1:60 - 1:70 - 1:100 - 1:160 -
1:260 - 1:1000.
3) tool speed in rpm;
4) power output in percent from 25 to 100 (99) in 5% steps;
5) water volume in percent from 25 to 100 (99) 5% steps;
6) water pump selection (H2O) or deselection (DRY); if H2O is selected
LED 1 (Fig. 5) will illuminate;
7) direction of rotation (SX – left or DX - right); if SX is selected the
appliance emits an audible signal (only when the footswitch is
pressed) and LED 2 (Fig. 6) illuminates;
8) micromotor selection (M1 or M2).
Carlo de Giorgi
5
7
Fig. 6
1
00
40 55
4 5
6 2
1
2 3
1/0100 200
H2O DX M1
6 7 8
4
3
Fig. 7
Fig. 8
GB - 9