Agu SN10 Mode D'emploi page 77

Harmonic emissions
IEC 61000-3-2
Voltage fluctuations/
flicker emissions
IEC 61000-3-3
Guidance and Manufacturer's declaration – electromagnetic immunity
The device is intended for use in the electromagnetic environment specified below. The customer or the user of
the device should assure that it is used in such an environment
IEC 60601
Immunity test
test level
Electrostatic dis- ±8 kV contact
charge (ESD)
±2 kV, ±4 kV, ±8 kV,
IEC 61000-4-2
±15 kV air
Electrical fast ±2kV for power sup-
transient/burst ply lines
IEC 61000-4-4 ±1 kV for Input/
output lines
Surge 1kV line(s) to line(s)
2kV line(s) to earth
IEC 61000-4-5
<5 % UT
interruptions and
voltage variations (>95 % dip in UT)
on power supply in- for 0,5 cycle
put lines
40 % UT
(60 % dip in UT)
IEC 61000-4-11
for 5 cycles
70 % UT (30 % dip in
UT) for 25 cycles
<5 % UT (>95 % dip
in UT) for 5 sec
Power frequency
30 A/m
(50/60 Hz) mag-
netic field
IEC 61000-4-8
– is the AC mains voltage prior to application of the test level.
NOTE: U
T
EN
Not applicable
Not applicable
Compliance
level
±8 kV contact
±2 kV, ±4 kV,
±8 kV,
±15 kV air
Not applicable Mains power quality should be that of a typical
Not applicable Mains power quality should be that of a typical
Not applicable Mains power quality should be that of a typical
30 A/m
Electromagnetic environment – guidance
Floors should be wood, concrete or ceramic tile.
If floors are covered with synthetic material, the
relative humidity should be at least 30 %
commercial or hospital environment
commercial or hospital environment
commercial or hospital environment.
If the user of the device requires continued oper-
ation during power mains interruptions, it is rec-
ommended that the device be powered from an
uninterruptible power supply or a battery
Power frequency magnetic fields should be at
levels characteristic of
a typical location in a typical commercial or hos-
pital environment
77