Device Cleaning - Agu SN10 Mode D'emploi

10

DEVICE CLEANING

Clean the medication chamber with distilled water after each use, before transportation or storage.
WARNING
1 Remove the medication residues.
• Open the medication chamber lid and remove the medication residues.
Use citric acid solution* to clean the medication chamber.
Method of preparation of citric acid solution: take a clean container or glass and pour 100 ml of
drinking water into it. Add half a teaspoon of edible citric acid (approx. 2.5 – 3 g) and mix thoroughly.
*Use crystalline or powder citric acid to prepare the solution.
• Press and hold the I/O button for 5 seconds. Еhe device will turn on and switch to cleaning
mode, the medication chamber LED will flash blue at a rate of about 3 times per second, and the
network indicator will start flash
• ing orange against a constant green light. Spray the citric acid solution for 2 minutes to
remove the medication residues. If necessary, repeat the above procedure until the medica-
tion residue is completely removed.
WARNING
If citric acid solution in the medication chamber runs out, and the device produces a high-
frequency sound, press the I/O button to switch off the device. Otherwise, the membrane can
be damaged.
Please remove the medication residues after each use. Otherwise, the medication chamber
membrane can be clogged.
• Rinse the medication chamber with distiller water after cleaning with citric acid solution. To
do this, fill the chamber with distilled water up to the level of 6 ml, close the lid and shake
the chamber at least 5 times. Open the lid and remove water. Rinse the outer part of the
membrane with distilled water to remove the citric acid solution residue. Repeat the cleaning
procedure with distilled water at least 3 times.
2 Disassemble the nebulizer:
• Remove the decorative panel.
• Remove the medication chamber, inhalation mask or mouthpiece from the nebulizer.
WARNING
Rinse the inhalation mask with water and dry before the first use.
70