Agu SN10 Mode D'emploi page 67

Breathing can also be complicated by illness. To make inhalation procedures more comfortable for
the user, we have introduced the possibility to change the spray rate of the solution. The spray rate is
user adjustable.
ATTENTION
Spray rate adjustment is available for both standard and SMART modes. Spray rate adjustment
is only available when powered by USB-C 5V 1A!
Press the I/O button twice to change the spray rate in any of the operating modes.
Pay attention to the LED located under the I\O button.
LED blinked 1 time: minimum spray rate is selected.
LED blinked 2 times: average spray rate is selected.
LED blinked 3 times: maximum spray rate is selected.
2
ATTENTION
• If the device does not detect the medication in the chamber, it will automatically switch off.
• If the device does not switch off automatically when the medication runs out, press the I\O
button to turn off the power immediately to avoid damage to the membrane.
• During inhalation, the nebulizer can be held at any angle, however, make sure that the
medication gets on the membrane, otherwise the device will switch off automatically within
15 seconds.
• When the medication runs out during inhalation, it is recommended to tilt the device (face
side) slightly towards yourself. So the rest of the medication will get on the membrane and
will be sprayed.
• Do not shake the nebulizer intensively during operation, otherwise the device may automati-
cally switch off.
• Ensure close control over a child who uses the nebulizer.
EN
1
3 x2
DC 5 V / 1 A
x2 x2
minimum average
spray spray
x1 x2
x2
maximum
spray
x3
67