Agu SN10 Mode D'emploi page 75

Nebulizer Medication chamber is not securely
turns off during installed
operation
USB-C cable is not properly connected
to the nebulizer
Medication has run out
Medication does not get on the mem-
brane for more than 15 seconds
Nebulizer The nebulizer was shaked up during
turns off during operation
operation
Medication chamber is damaged
Some inhalation solutions may form a
large amount of foam in the medication
chamber
Medication chamber contacts are con-
taminated with medication or water
Nebulizer and medication chamber con-
tacts are contaminated
Medication Medication chamber is damaged or
leaks from the silicone gasket is worn out
medication
chamber
Nebulizer Inhalation valve and/or exhalation valve
constantly sprays is blocked
solution even in
SMART mode
Maximum spray Maximum spray rate can be selected
rate cannot be only when an external power supply is
selected connected via USB-C
Insufficient negative pressure is created
No spraying
when inhaling in when you breath in
SMART mode
If your nebulizer is still not working properly, please contact the service center.
EN
Install the medication chamber properly and start
spraying
Install properly and restart the device
Add the medication to the chamber
Place the nebulizer at an angle so that the medi-
cation gets on the membrane
Securely hold the nebulizer in your hand
Replace the medication chamber with a new one
and fill in the medication
Remove foam and restart the device
Clean the contacts from medication or water resi-
dues and restart the device
Clean the contacts and restart the device
Replace the medication chamber with a new one
and fill in the medication
Eliminate the cause of the valve blocking. Check
the valve travel by blowing the connecting piece
Connect an external 5V 1A power supply with a
USB-C cable
Use the mouthpiece instead of the mask. Breathe
normally
75