Binding; Range-Checking The Radio System; Using The Dig Transmission - Horizon Hobby Axial Capra Manuel D'utilisation

EN

BINDING

Binding is the process of programming the receiver to recognize the
GUID (Globally Unique Identifi er) code of a single specifi c transmitter. The
STX3™ transmitter and SPMSRX300 receiver are bound at the factory. If
you need to rebind, follow the instructions below.
1. Insert the bind plug in the BIND port on the receiver.
2. Connect a fully charged battery pack to the ESC.
3. Power on the ESC. The red receiver LED fl ashes, indicating the
receiver is in bind mode.
4. Center the ST TRIM and TH TRIM dials on the transmitter.
5. Turn and hold the steering wheel fully right, then power the transmitter
on.
6. When the receiver LED stops fl ashing, release the steering wheel.
7. Remove the bind plug, then power off the receiver to save the settings.
8. Power off the transmitter.
9. Store the bind plug in a convenient place.
You must rebind when:
• Different failsafe positions are desired e.g., when throttle or steering
reversing has been changed.
• Binding the receiver to a different transmitter.

RANGE-CHECKING THE RADIO SYSTEM

The radio system should be checked before operating the vehicle to ensure proper operation and adequate range.
1. Turn on the transmitter.
2. Connect the battery in the vehicle.
3. Have a friend hold the vehicle while keeping hands and loose clothing away from moving parts.
4. Walk away until you are at the maximum planned operating distance from the vehicle.
5. Turn the steering wheel side to side and operate the throttle, both forward and reverse, checking for any erratic behavior.
6. If any erratic behavior is exhibited, DO NOT operate the vehicle. Call customer service for assistance.

USING THE DIG TRANSMISSION

The Axial Capra includes a "Dig" transmission which allows the rear
axle to lock while still allowing the front wheels to spin. Use this feature
in close quarters to turn the vehicle tighter than is possible with normal
4 wheel drive or to preload the suspension when needed.
To use the Dig function:
1. Press the channel 3 "Top" button on the transmitter. The Dig function
engages, locking the rear axle.
2. Advance the throttle and turn the steering wheel left or right to tightly
pivot the vehicle around.
3. Press the channel 3 "Bottom" button to disengage the Dig function.
Ch 3 Top
Ch 3 Bottom
8
Bind Port