Tool Identification; General Notes And Use; Main Components; Technical Data - FAR KJ 70 Traduction Des Instructions Originales

TOOL IDENTIFICATION

The riveting tool KJ 70 is identified from a marking that shows
company name and address of manufacturer, designation of
the tool, CE. Always refer to the information on the riveting tool
when requesting technical service.
Company name and
address
Serial number

GENERAL NOTES AND USE

The tool can be employed only for blind rivet nuts with thread
of M3 ÷ M12 diameter.
The KJ 70 oil pneumatic system assures more power than
the pneumatic system used for other models. That means
a reduction in the problems due to the wear and tear of the
components, therefore, there will be an increase in reliability.
The technicai solutions adopted reduce the dimensions and the
weight of the tooi which, for these reasons, make it very handy.
The possibilities of leakage from the oil-dynamic system, are
eliminated by some sealed gaskets, which solve this problem.
10
Designation of
the tool
KJ 70
Date 07-2016
GB

MAIN COMPONENTS

A) ..................................................... Ring nut clamping head
B) ................................ Insertion Pin Hole Dechucking clutch
C) ...........................................................Balancer connection
D) ................................................Ring nut adjustment stroke
E) ............................................................... Pneumatic motor
F) .................................................................Threaded tie rod
G) ...................................................................................Head
H) ........... Drive trigger: Pos. 1 Tiraction - Pos. 2 Unscrewing
I) ...................................................
L) .......................................................................Oil filler plug
M) ...................................................................... Service plug
N) ................................................................ Oil level indicator
350
B
90
A
Ø 25
G
F
2
H
1

TECHNICAL DATA

• Working pressure ......................................................6 BAR
• Min. int. diam. of the compressed air
feeding hose ....................................... min. diam = 8 mm
• Air consumption per cycle ...................................... 10,4
• Max power .................................................6 BAR -13656 N
WEIGHT:
• Gun ....................................................................... 2,050 Kg
• Total ...................................................................... 6,850 Kg
• Working temperature ...........................................-5°/+50°C
• Root mean square in total acceleration frequency (Ac)
to which the arms are subjected. ........................ < 2.5 m/s
• A-weighted emission sound pressure level ............. 82 dBA
• Peak C-weighted instantaneous sound pressure <130 dBC
• A-weighted sound power ........................................ 90 dBA
AIR FEED
The air feed must be free from foreign bodies and humidity in
order to protect the tool from premature wear and tear
of the components in movement, therefore we suggest to use
a lubrificator group for compressed air.
Compressed air connection
E
D
C
Ø 44
M
L
N
315
265
150
Revisione - 12
KJ 70
165
I
Nl
2