KIKKA BOO TWIDDLE Mode D'emploi page 6

2. ASSEMBLY
2.1. Install the Bottom Frame. As shown, take the screw out of tube, then make the left and right tubes insert hole, make the
hole position on the tube and the support assembly, and then tighten the screw with a screwdriver.
2.2.Install the seat, s shown, hold-down the spring leaf on seat , then insert the seat into the holder until a ''click''
2.3.Install the toy bar, as shown, insert the toy bar into the seat.
2.4. Put the toys into the hole of toy bar, can adjust toys to x it.
3. BATTERY ASSEMBLY
Battery Size: 1.5V 4*AA/LR6 (Not Included )
Install batteries if you need to use this swing away from an outlet.
We recommend using Alkaline batteries for longer battery life.
*Loosen the screw in the battery compartment door with a scewdriver (not included)and remove the battery compartment
door.
*Insert four AA(LR6) alkaline batteries into the battery compartment.
*Replace the battery compartment door and tighten the screws.
Note:Low battery power may cause product movement to slow,sound and lights to become faint or product to turn o all
together. If this should happen, use the AC adaptor as a power source or replace the batteries. Replace the batteries with four
alkline AA (LR6) batteries.
*If this product begins to operate erraticaly ,you may need to reset theelectronics.Turn the power o and then back on.
4. SWING CONTROL PLATE INSTRUCTIONS
1. Power on/o ; 2. 12 songs; 3. 5 speeds; 4. 3 timers; 5. Power light; 6. Volume(-); 7. Remote control signal receiver;
8. Volume(+); 9. Timer lights; 10. Motion control light; 11. Motion button; 12. Speed lights; 13. 5 natural songs;
Power on/o : Press button, the swing connects with power, and power light turns red.
Natural song button :5 natural songs, press the button to start from one song, press again to move to next one.
Speed button: 5 speeds, each speed has a speed light. press the button to start from 1st speed, press again for 2nd speed.
Timer button:3 timers, 15 mins,30 mins, and 60mins. press button to move to the next timer. each timer has a timer light.
Song button: 12 songs totally, press button to start from one melody, press again to move to next one.
Volume +/-, press this buttons to adjust the volumn of songs.
Motion button: After baby fall asleep. can select this function,motion detector starts swinging when the baby shakes from
crying.
Motion button lights: Press the motion button and the motion indicator lights up.
When the baby wakes up and ips in the swing, the swing function starts automatically.
5. REMOTE CONTROL FUNCTIONS (SELECTIVE):
1. Power(press this button to close all functions ; 2.Speed button (5 speeds) ; 3. 3 timer buttons(15 minutes, 30 minutes, 60
minutes) ; 4. Music button 12 melodies, press the button to move to the next one; 5. Volume decrease ; 6. Volume increase;
7. 5 nature songs , press the button to more to next one; 8. Motion button; 9. Button battery CR2025 3V (including);
MAINTENANCE
This product requires regular maintenance to keep it in good working order. Regularly check all parts of the product to ensure
that they are operating correctly and for signs of wear or damage. Only replacement parts supplied or recommended by the
manufacturer should be used.
CLEANING
Refer to care label on the product for cleaning instructions for fabrics. Clean metal or plastic components with mild detergent
and warm water. Never use abrasive, ammonia based, bleach based or spirit type cleaners. Ensure the
product is fully dry before use or storage.
ENGLISH