General Safety Rules - Genesis GDP1012A Manuel D'utilisation

10" 12-Speed Drill Press
Operator's Manual
SPECIFICATIONS:
• Model: -------------------------------- GDP1012A
• Rated Power: ------------------------- 120V~ /60 Hz, 3.85 Amp
• No Load Speed: -----------------------12 Speeds (300- 2900 RPM)
• Chuck Size: --------------------------- 5/8" (16 mm)
• Spindle Travel: ------------------------ 2-3/8" (60mm)
• Swing: -------------------------------- 10" (254 mm)
• Table Movement:---------------------- 45° bevel, 360° swivel
• Table Size: ---------------------------- 7-5/8" x 7-5/8" (200 mm x 200 mm)
• Base Size: ---------------------------- 14" x 9-1/4 " (355mm x 235 mm)
• Max. Distance from Spindle End to Surface of Table:-------- 11-3/8" (290 mm)
• Max Distance from Spindle End to Surface of Base: --------- 1 6-1/4" (414 mm)
• Max Distance from Spindle Axis to Surface of Column: ----- 5 " (127 mm)
• Net Weight: ------------------------------------------------- 55 Lbs
Includes: Chuck Key, Allen Wrenches and Drift key
WArNINg:
operator's manual before operating this tool. Save this Manual for future reference.
Toll-Free Help Line: 1-888-552-8665
WEAR YouR
SAfETY GLASSES
foRESIGHT IS BETTER
THAN No SIGHT
Look for this symbol to point out important safety
precautions. It means attention!!! Your safety is
involved.

gENErAL SAFETY rULES

WArNINg:
other construction activities contains chemicals known to cause cancer, birth defects or
other reproductive harm. Some examples of these chemicals are:
• Lead from lead-based paints,
• Crystalline silica from bricks and cement and other masonry products, and
• Arsenic and chromium from chemically treated lumber.
Your risk from these exposures varies, depending on how often you do this type of work. To reduce your
exposure to these chemicals: work in a well ventilated area, and work with approved safety equipment, such as
those dust masks that are specially designed to filter out microscopic particles
2
To reduce the risk of injury, user must read and understand this
WArNINg:
objects being thrown into your eyes, which can result in severe eye damage. Before
beginning tool operation, always wear safety goggles or safety glasses with side
shields and a full face shield when needed. We recommend Wide Vision Safety Mask
for use over eyeglasses or standard safety glasses with side shields. Always wear eye
protection which is marked to comply with ANSI Z87.1.
Some dust created by power sanding, sawing, grinding, drilling, and
10" Drill Press
Operator's Manual
The operation of any power tool can result in foreign
.
GDP1012A
3.85AMP