Notes On Device Safety - Zeiss Stemi 305 Mode D'emploi

Stereo microscope
Stemi 305 cam
1.2

Notes on Device Safety

If it becomes apparent that the safety measures are no longer effective, the device must be
taken out of service and secured against being used again unintentionally. Please contact
ZEISS customer service or the Carl Zeiss Microscopy Service to have the device repaired.
The Stemi 305 Information regarding device safety and installation conditions 435063-6044-
008 and the Stemi 305 Concise operating instructions 435063-8044-008 as well as the
operating instructions regarding the light sources also must be observed.
Do not operate the devices included in the scope of supplies in a potentially explosive
atmosphere, in the presence of volatile anaesthetics or flammable solvents such as alcohol,
gasoline or similar substances.
The devices may only be operated by instructed persons who have been informed about the
possible risks in conjunction with the use of microscopes and the fields of application in
question. The microscope is a high-precision device that may be impaired in its performance or
even destroyed if handled improperly.
Before commissioning the device, make sure that the existing power supply is suitable for the
device.
Make sure that the mains plug is removed from the socket before the device is opened.
The devices are not equipped with special equipment protecting them from corrosive,
potentially infectious, toxic and radioactive or other samples that may be hazardous to health. If
you handle such samples, be sure to observe all legal requirements, in particular the relevant
national accident prevention regulations.
The LED reflected light illuminators and the LED transmitted light illuminators have been
classified as belonging to LED risk group 2 acc. to DIN EN 62471:2009. Avoid looking directly
into the LED light.
If the device is operated with an external cold light source (high-energy light), never look
directly into the fibre optic output of the cold light source. Otherwise, there is a risk of dazzling
and blindness.
The Stemi 305 cam body with Wi-Fi may only be used if it is covered by a radio license for your
region. For further information on the radio licences, see Annex to the operating manual. If
necessary, contact your regional ZEISS representative.
03/2015
INTRODUCTION
Notes on Device Safety
435063-9044-008
ZEISS
3